Charge plus’s Battery Protector is designed as a Low battery cut-out switch with build in over-current protection circuit, both crucial features to protect your expensive batteries from over discharging and or a short circuit. Compared to the other Low battery cut-outs the Charge Plus unit has the additional function of a 15 amp Over Current protection ( This is not designed to protect againest shorts on the output wiring. You need to fit an output 15 to 20 Amp fuse if you require protection againest short circuits. )

The Charge Plus unit is small in size (58mm L x 40mm W x 26mm H) so they can be stacked together to make a fuse box.

Charge plus’s  Battery Protector has the following general functions:

1. The unit is designed to be configured as either automatic resetting or manual resetting.
2. The unit will trip out to protect the battery if the battery voltage falls below 10V for a period of time.
3. The unit will trip out if the load current exceeds 15 amps (but not dead short to ground).
4. There is a push button which is used to reset the unit when it trips out or it can be used to switch off the circuit.
5. The unit is fitted with a LED to indicate the current load on the output and status.

The Charge plus Battery Protector is designed using Nanowatt technology and clever software that flashes the LED, has a no load standby power consumption of less than 2mA in auto mode or less than 1mA in manual mode.
Even at higher power outputs of more than 1 amp the consumption is a maximum of 15mA. Other units in the market which are only low voltage cut-outs are around 50mA even at no load.
The charge Plus unit is truly Automotive Load Dump and Voltage rated to O.E. standards and have an operating voltage range to suit 12 volt vehicles ( 9 volts to 20 volts )